7/23/2023 0 Comments Fast emulsion filmEZ-50 ORANGE can be adhered with plain water, or with ORANGE emulsion in the direct/indirect mode. EZ-50 ORANGE (50 microns) is recommended for use with mesh counts ranging from 33 to 77 threads/cm. EZ-50 ORANGE is coated on 300-gauge matte polyester. EZ-50 ORANGE is fast exposing and its high-contrast orange color masks halation and light scattering, thereby improving resolution without the need to use more-costly dyed mesh. They will dry quicker, and the emulsion will continue to crosslink and harden, creating a more durable stencil.ULANO EZ-50 ORANGE is a pure photopolymer (SBQ), pre-sensitized capillary film appropriate for general sportswear printing. On sunny days, dry your screen in the sunlight.Hitting your screen with full UV light after it is rinsed out will continue to cross link the emulsion, making it harder and less susceptible to breakdown, pinholes etc. ![]() This can be done by simply placing the screen in the sunlight after it is washed out, or back on the exposure unit for a minute or 2. Post expose your screens for added durability. Even if you are rinsing your screens inside, in low light conditions, submerging your exposed screen in water will start to loosen the unexposed emulsion and require less water in the washout booth, and less water down the drain.Just getting them wet will stop the emulsion from continuing to expose, allowing you to take your screen into full sunlight to rinse out.Anywhere from 30 seconds to 2 minutes has worked in my experience. Pre-develop your screens by submerging them in water. SCREEN PRINTING CAPILLARY FILM Our range includes diazo-based, hybrid and photopolymer capillary films suitable for use with solvent-based, UV and co-solvent inks (mixed water and solvent-based inks), and a range of high thickness films for the textile industry.When exposed properly, your stencil should last for thousands of prints. ![]() If your stencil is not properly exposed and hardened, it can break down during the print process, and you will have to re-burn screens, possibly holding up production and missing deadlines, etc.ĭurability of your stencil is most important. Under exposure of screens will cost you time & money, and cause undo stress. If you are trying to get the fastest burn times possible, chances are your stencils will be underexposed. Quick exposure is nice, but it is not the most important. Assuming speed is the most important factor when burning a screen This is assuming you are not starting out with a RIP Software.Ģ.
0 Comments
Leave a Reply. |